在cfx计算，想把结果（.res)文件导入 fluent中

yangyu96

我在cfx计算，想把结果（.res)文件导入 fluent中，出现：

> Reading "\"| utility fe2ram -tCFXD -d3 -m0 -zCCL  \"\"E:\qifeng\qifeng14 ssg angularinletvelocity temperature473_001.res\"\"\""...
  
Error: bad syntax. Usage:
utility fe2ram dimension read_format zoning write_format [inputfile [outputfile]]
dimension: [-d2 | -d3 | -surface]
read_format: [-tANSYS | -tCFX | -tCFXD | -tCFXR | -tCGNS |
  -tFIDAP7 | -tFLUENT4 | -tFLUENT4UNI | -tGAMBIT | -tHYPER |
  -tIDEAS | -tDYNA | -tNASTRAN | -tOIV | -tPATRAN |
  -tPLOT3DB | -tPLOT3DBI | -tPLOT3DF | -tPLOT3DFI | -tPROE |
  -tRAMPANT | -tSTAR16 | -tSTL | -tYAMS | -tFTL |
  -tVRML | -tWAVEFRONT | -tGAF | -tTECPLOT]
  zoning: [-zGROUP | -zID | -zPRESSURE | -zTEMPERATURE | -zNONE]
  default is -zGROUP.
write_format: [-oFIDAP7 | -oRAMPANT]

Error: bad syntax. Usage:
utility fe2ram dimension read_format zoning write_format [inputfile [outputfile]]
dimension: [-d2 | -d3 | -surface]
read_format: [-tANSYS | -tCFX | -tCFXD | -tCFXR | -tCGNS |
  -tFIDAP7 | -tFLUENT4 | -tFLUENT4UNI | -tGAMBIT | -tHYPER |
  -tIDEAS | -tDYNA | -tNASTRAN | -tOIV | -tPATRAN |
  -tPLOT3DB | -tPLOT3DBI | -tPLOT3DF | -tPLOT3DFI | -tPROE |
  -tRAMPANT | -tSTAR16 | -tSTL | -tYAMS | -tFTL |
  -tVRML | -tWAVEFRONT | -tGAF | -tTECPLOT]
  zoning: [-zGROUP | -zID | -zPRESSURE | -zTEMPERATURE | -zNONE]
  default is -zGROUP.
write_format: [-oFIDAP7 | -oRAMPANT]
Building...
     mesh
Primitive Error at Node 0:
Partition: cell count = 0; count must be greater than zero.
Primitive Error at Node 1:
Partition: cell count = 0; count must be greater than zero.
Primitive Error at Node 2:
Partition: cell count = 0; count must be greater than zero.
Error:
Partition: cell count = 0; count must be greater than zero.
Error Object: #f
怎么回事？谢谢

yangyu96

难道没有人这么做过？

Monica2016

同问，请大神帮帮忙