Advanced Control of CFX-Flow Parameters

yangyu96

在cfx的帮助中有

*** INSUFFICIENT MEMORY ALLOCATED ***

Action required:

Depending on what program is running, there then follows a message relating to what memory stack is full. If the program is CFX-FLOW, then the following message is shown:

Re-run CFX-Pre and increase the CDTYPE stack memory factor. Use the Workspace Sizes menu under Advanced Control of CFX-Flow Parameters.

其中Advanced Control of CFX-Flow Parameters选项在哪可以找到，谢了

seaharrier

原帖由 yangyu96 于 2012-2-21 07:21 发表

                               
登录/注册后可看大图

在cfx的帮助中有

*** INSUFFICIENT MEMORY ALLOCATED ***

Action required:

Depending on what program is running, there then follows a message relating to what memory stack is full. If the program ...

这个选项倒不知道，
你的内存不够了吧。